DIY Wedding Part 1

Hi Everyone!! Seeing that summer time is a time where most people like to get married, I thought I would share some DIY items that you can make.  While making things yourself sounds like fun, there is a lot of work that goes into them.

We will start off this little series with the Invitation. With the help of the Cricut Cartridge George and Basic Shapes and Cricut Design Studio Software, this outer envelope was designed. The Response card (embossed with wedding bells) and Envelope was set inside the center. A photo is "hanging" on the right hand side, and the Directions & Information is inside a pocket on the left. The top and bottom flaps are also embossed.

The envelope folds up and is held close with a Monogram Band.

You can see here the embossing on the top and bottom flaps of the envelope.

Thank you for viewing this post, and check back tomorrow for another DIY Wedding Project!!